HomeServicesMaintenance Tips


Check Operation of:

1)

Induced draft fan motor

2)

Chimney

 

3)

Boiler

Operation of automatic feed, back-flow preventer, expansion tank, water temperature, and pressure relief valve

4)

Condensation Trap and Line

   

- Piping
- Barometric damper operational and level

5)

Flue

- Ignition module
- Gas cock, rusted or damaged lines

6)

Humidifier

- Water tray, clean as necessary
- Saddle valve and water line

7)

Thermostat

- Calibration
- Standard T87F**

8)

Safety Switches

   

- Hi and low limit and pressure switches

9)

Gas piping

- Ignition module
- Gas cock rusted or damaged lines
- Zone valves

10)

Blower

- Fan blade balance
- Oil or grease motor and bearings as required

11)

Burner and burner motor

   

- Replace fuel nozzle
- Oil pump drive, fan and screen

12)

Change tank filter*

13)

Replace standard air filters

14)

Clean flue passages in boiler

15)

Measure carbon monoxide levels

 

 

 

 

=

heat exchangers, fire boxes and condensate pumps are excluded from coverage.

* =

oil-fired boiler

** =

digital thermostat at replacement value

 


M.J. Emonds Mechanical Contractors, LLC
17 Nutmeg Lane, Glastonbury, CT 06033
tel. 860.657.4554 fax 860.657.4558
e-mail: info@emonds.com